Installation
Instructions
4335.020.XXX
PEKOE EXTENDER
SINGLE CONTROL KITCHEN
POP-OUT SPRAY
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Certified to comply with ANSI A112.18.1M
M968582 REV.1.1
Recommended Tools
Phillips Screwdriver
Channel Locks
Adjustable Wrench
Tubing Cutter
Plumbers' Putty or Caulking
INSTALL FITTING
1
Turn off hot and cold water
supplies before beginning.
CAUTION
Make certain the SEAL (1) is properly seated in recess
of faucet body.
Insert supply HOSES (2) and SHANK (3) through center
hole of sink or mounting surface.
Assemble RUBBER WASHER (4), PLASTIC WASHER (5),
METAL WASHER (6) and threaded LOCKNUT (7) onto
SHANK (3) from underside of sink or mounting surface.
Hand tighten LOCKNUT (7) and check that faucet is centered.
Use a screwdriver to tighten SCREWS (8) on LOCKNUT (7).
Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
RECESS
3
1
2
4
5
6
7
8
SERVICE
4
Clogged CARTRIDGE outlets or inlets may cause reduced
flow. To clean, first turn off water supply then:
Loosen and remove LEVER HANDLE (1). Loosen
HANDLE SCREW (2) with 2.5mm Hex Wrench and
then pull HANDLE BASE (3) off.
Unscrew ESCUTCHEON CAP (4). Unscrew the
CARTRIDGE NUT (5) and remove METAL WASHER (8).
Remove CARTRIDGE (6). Clean inlets of
CARTRIDGE (6) and MANIFOLD (7).
METAL
WASHER
8
CLEAN
Reassemble CARTRIDGE (6). Replace CARTRIDGE
NUT (5), CAP (4), METAL WASHER (8) and
HANDLE assembly, check flow.
1
5
4
7
2
6
3
SERVICE
5
If SPOUT (1) leaks at swivel point the O-RINGS (2) need
to be replaced. To remove SPOUT (1):
Turn faucet to off position. Loosen the SPOUT SET SCREW (3)
with a 3mm Hex wrench.
Rotate the SPOUT (1) side to side while pulling upward to
remove SPOUT (1) from faucet body.
Replace the defective parts and grease O-RINGS (2). Push
SPOUT (1) back into position. Tighten SET SCREW (3).
1
REMOVE
INSTALL
Check that SPOUT (1) rotates freely and does not leak
at the swivel point.
2
3
3mm HEX
WRENCH
CARE INSTRUCTIONS:
6
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
M968582 REV.1.1
|