Technical Specifications
Version 1.0
December 2001
Transducer type:
Operating principle:
Polar pattern:
condenser, 1" single diaphragm
pressure gradient
cardioid
Connection:
gold-plated balanced XLR connector
-34 +/-2 dBV (0 dBV = 1 V/Pa)
20 mV/Pa
Open circuit voltage at 1 kHz:
Open circuit sensitivity:
Frequency range:
Level attenuation:
Low-Cut filter:
Max. SPL (1% THD @ 1 kHz):
Equivalent SPL (IEC 268-4):
Signal-to-noise ratio re 1 Pa:
Nominal impedance:
Load impedance:
Supply voltage:
20 Hz - 20 kHz
-10 dB (switchable)
6 dB/Octave at 75 Hz (switchable)
138 dB (0 dB), 148 dB (-10 dB)
13 dB-A
81 dB A-weighted
50 W
> 1 kW
+48 V
Supply current:
3 mA
Dimensions:
Weight:
Æ: 58 mm, length: 174 mm
0,461 kg
Polar pattern
Frequency response
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be made
from time to time to existing products without prior notice. Specifications and appearance may differ from those listed or illustrated.
The information contained in this sheet is subject to change without notice. No part of this sheet may be reproduced or transmitted in
any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the
express written permission of BEHRINGER Spezielle Studiotechnik GmbH.
BEHRINGER is a registered trademark. ALL RIGHTS RESERVED.
© 2001 BEHRINGER Spezielle Studiotechnik GmbH.
BEHRINGER Spezielle Studiotechnik GmbH, Hanns-Martin-Schleyer-Str. 36-38, 47877 Willich-Münchheide II, Germany
Tel. +49 (0) 21 54 / 92 06-0, Fax +49 (0) 21 54 / 92 06-30
|