Avery Printer TC9820PHI User Manual

REP LACING THE P RINTHEAD  
The printhead is sensitive to static electricity, which can damage the  
printhead or reduce its life. Ground yourself by touching some metal, such  
as the printer's metal base, before touching the printhead.  
To replace the printhead:  
1. Turn off the printer.  
2. Open the cover.  
3. Unlock the printhead by turning the retaining latch.  
TC9820PHI Rev. AB 11/07  
©2001 Paxar Americas, Inc. a subsidiary of Avery Dennison Corp.  
All rights reserved.  
 
6. Carefully unplug the cable from the printhead as shown. The printhead  
is sensitive to static electricity, which can damage the printhead or  
reduce its life. Ground yourself by touching some metal, such as the  
printer's metal base, before touching the printhead.  
7. Carefully plug the cable into the new printhead.  
8. Align the new printhead with the tabs.  
3
 
9. Snap the printhead into place.  
Do not  
touch here  
Note: Make sure the printhead cable does not touch the ribbon roll.  
10. Clean the new printhead with a cotton swab dipped in isopropyl alcohol  
to remove any salt or oil left from handling.  
11. Let the printhead dry and reload your supplies.  
12. Push down on the printhead assembly to lock it in place.  
13. Close the cover.  
14. Turn on the printer and press Feed/Cut to position the supply.  
4
 

3M Projector 8749 User Manual
Acer Computer Monitor X163W User Manual
ACP EP Memory Camera Accessories 60X User Manual
Air King Ventilation Hood AK100FL User Manual
Airlink101 Network Router AR686W User Manual
AKG Acoustics Microphone C 419 User Manual
Alpine Speaker SWR 1023D User Manual
ATN Binoculars PS 23 User Manual
Avital Remote Starter 4501 User Manual
Beko Flat Panel Television 32WLU550FHID User Manual