User Instructions
®
American DJ
Flash-1C™
Thank you for purchasing this
America n D J ® product. For your
convenience this products ready to
be used, there is no assembly
required. Please read the following
instructions before installing or
using your new unit.
Caution! Always disconnect from main
power before servicing unit. Remember to
always replace with same fuses.
Operating Instructions:
The American DJ® Flash-1C, flash tube controller
is ideal for mobile DJ’s and club use. One Flash-
1C will control up to 20 Flash Tubes. The Flash
Tubes can be controlled in two ways AUTO or
MANUAL (blue button). When switch is on
MANUAL , the user has control of the SPEED and
and MODE knobs . Only by pushing the yellow
TRIGGER button, will the Flash Tubes light.
When switch is on AUTO, the user has control of
SPEED, MODE, and pulse RATE knobs.
Model: Flash-1C™
SPECIFICATIONS:
Power: 110V/60Hz
Weight: 3 lbs.
Size: 11.25” x 5.25” x 3”
Fuse: 10A
SPEED knob - Controls speed of chase.
MODE knob - Coose 1 of 5 mode to chase in.
1. Forward 2. Reverse
3. Crossover 4. Rebound
5. Auto chase
RATE knob - Controls rate of pulse (ie. speed of
strobe) of the Flash Tubes.
For service, contact your American DJ ® dealer.
LOS ANGELES, CA. 90058 USA
®
American DJ
|