Vandal and Weather Resistant 1-Gang Sub Station
- INSTRUCTIONS -
The LE-SS-1G is a 1-gang stainless steel vandal proof and weather resistant sub station designed for use with the
LEM, LEF, LAF/LDF-C, AP-M, and MP-S systems. This unit is constructed with 12 gauge stainless steel and can be
flush mounted into a 1-gang box, or surface mounted with the SBX-1G. Each unit includes tamper proof screws and a
tool for installation.
INSTALLATION:
1. For flush mounting, install sub station in standard 1-gang electrical box with min. 2-1/2" depth.
2. For surface mounting, install sub station in the SBX-1G surface mount enclosure.
3. IMPORTANT! This unit is designed for use in normal weather conditions, and is made to allow for drainage and
evaporation of moisture that naturally gets into it. Do not apply caulking or silicone sealant around the unit
when installing, and do not use weather stripping around the perimeter of the box when mounting. If
sealing the unit is required, the bottom must remain unsealed. Sealing the unit will prevent or inhibit moisture from
dissipating from inside the unit, which may cause corrosion or deterioration to the internal components over time.
Warranty does not cover damage caused by sealing the unit.
1-15⁄16”
LE-SS-1G
2-⅞” 3-¼”
Back View
WIRING DIAGRAMS:
LEM SYSTEM:
2 conductor
shielded wire
LEM Master
LE-SS-1G
1
E
Red
Blk*
Blu
Power
Source*
Jumper Blue & Black
wires together.
*LEM-1 or LEM-3: Use SKK-620
(6V DC)
+
-
+
-
LEM-1DL: Use PT-1210N
(or any source providing
12-16V AC or 12-24V DC)
WIRE COLOR CODE DEFINITIONS:
Red: + side of speaker & call switch, connect to # of master
Black: Common communication, connect to E of master
Blue: - side of call switch
LEF, LAF-C, or LDF-C SYSTEM:
LEF, LAF/LDF-C
Master Station*
LE-SS-1G
LE-SS-1G
Red
1
2
Red
~
10
3 conductor
shielded wire
* In a single master LEF system
only, 2 conductors homerun can
be used with the BLK and BLU
wires tied together and "E" and "-"
PS-1225UL
Blk*
Blu
E
+
-
Blk*
+
-
Blu
jumpered at the master station.
Page 1
|