Agilent Technologies TV Cables 5060 3386 User Manual

DC MODULE CONNECTORS  
Installation Guide  
Standard Connector (P/N 5060-3386)  
Relay Connector (P/N 5060-3387)  
+Sense used to connect the + remote sense lead. Set the  
sense switch to Remote when this connection is  
used.  
General Information  
Load connections are made on the connector supplied  
with each module. The connector is fastened to the back  
of the mainframe. Modules can then be installed or  
removed from the mainframe without disturbing the  
wiring on the connector.  
-Sense used to connect the - remote sense lead. Set the  
sense switch to Remote when this connection is  
used.  
GND  
used for signal ground (GND) connections.  
The connector has a switch to select either local or remote  
voltage sensing, depending on how the load is connected.  
Connect the Wires  
A relay connector is identified by a check mark on the  
Relay label on the connector. Relay connectors include  
load and sense disconnect and polarity reversal relays.  
Loosen the barrier block screws and connect the wires.  
The barrier block accepts spade or ring terminals. You  
can also connect a stripped wire to the barrier block.  
Twist the wire around under the screw terminal and  
tighten the screw.  
Making Load Connections  
Load connections are the same on both the standard and  
the relay connector.  
Open the Connector  
Open the connector by loosening the four corner screws  
(M3 X 10 mm).  
TIE  
WRAP  
Route the wires out of the bottom of the connector as  
shown in the figure above. Use the tie-wrap supplied  
with the connector to secure the wires to the connector.  
CAUTION  
Hand tighten only.  
Start all screws  
before tightening.  
Close the Connector  
Tighten screws evenly.  
DO NOT overtighten screws.  
DO NOT use locking-type  
adhesive on the screws.  
Close the connector and tighten the four corner screws.  
Observe the  
on the figure.  
CAUTION  
Attach the Connector to the Mainframe  
A five-terminal barrier block is provided for wire  
connections. The barrier block screws are 6-32 x 1/4 inch  
(equivalent p/n 2470-0001). The barrier block terminals  
are labeled as follows:  
Attach the connector to the back of the module on the  
mainframe at the appropriate slot location. Tighten the  
two screws (M3 x 10mm) on the connector. Observe the  
on the figure.  
CAUTION  
+Output used to connect the + output load wire.  
-Output used to conect the - output load wire.  
Agilent p/n 5959-3366  
May, 2000  
Microfiche p/n 5959-3367  
 

4XEM Gas Grill C86 User Manual
ABC Office Home Security System 06502 User Manual
Agilent Technologies Computer Accessories G3180B User Manual
Alliance Laundry Systems Washer Dryer CPD6C User Manual
Allied Telesis Switch Layer 3 Switches User Manual
Altec Lansing Headphones AHP 612 User Manual
Altec Lansing Portable Speaker AVS300 User Manual
Amana Microwave Oven FE116T User Manual
ATI Technologies Portable Multimedia Player ATI Multimedia Center 81 User Manual
Barco Frozen Dessert Maker R59770497 0A User Manual