Commercial Storage Tanks
UNINSULATED
MODELS
STANDARD STOCK BARE STORAGE TANKS
T-80
THROUGH
A. O. Smith commercial hot water storage tanks are designed for use with gas/electric water
heaters and boilers to provide additional hot water storage capacity for systems with large hot
water draws. A. O. Smith glass-lined storage tanks are designed and recommended for systems
with operating temperatures up to 180°.
T-1000
PERMAGLAS® GLASS LINING
n
All internal surfaces exposed to water are glass-lined per ASME HLW procedures,
using an NSF-approved glass-lining compound
n
Glass is highly resistant to effects of temperature, corrosion and electrolysis
SIZES FROM 80 TO 1,000 GALLONS IN STOCK
n
All tanks in table on reverse side are normally carried in stock for immediate
shipment, providing a fast solution for retrofit requirements
HORIZONTAL OR VERTICAL MOUNTING
n
A. O. Smith standard stock tanks (except the T-80S, T-120S and TL-500A) are
shipped factory standard with leg sockets for vertical installation,
but are also designed to have the proper inlet/outlet openings
that allow horizontal installation
n
For horizontal installations, optional tank saddles are
required (TL-500A is horizontal only)
T-325 ASME RETROFIT SPECIAL
n
The T-325 ASME (34 x 84) is designed to provide maximum storage
capacity and fit through a 36” door
MAGNESIUM ANODES
n
For extra protection against corrosion
WORKING PRESSURES
n
Tanks tested at pressures assigned in accordance with working pressures shown in table
on reverse side
CUSTOM TANKS
n
In order to offer storage tanks for immediate shipping, the A. O. Smith Standard
Stock Tanks are offered with only those openings and features shown in the
following tables
n
A. O. Smith also offers a full line of custom tanks from 80 to 12,500 gallons built to meet
(OPTIONAL)
your specifications and are available with many options such as various working
pressures, lifting lugs, handholes, manholes, special linings, special openings, factory
jacket/installation, and built to military specifications
n
For custom tanks, please see the A. O. Smith Custom-Line HD storage
CRN
tank spec sheet
Page 1 of 4
June 2008R
AOSTT35300
Commercial Storage Tanks
DIMENSION AND SHIPPING WEIGHTS
Working pressure for Std. models T-80, T-120 and T-200: 150 psi
Working pressure for ASME models T-140 and T-200 through T-1000: 125 psi
OPTIONAL TANK SADDLES FOR HORIZONTAL TANK INSTALLATIONS
HORIZONTAL TANK SADDLES
B
5’
(NOM.)
A
Page 3 of 4
AOSTT35300
Commercial Storage Tanks
UNINSULATED
STANDARD STOCK BARE STORAGE TANKS
SUGGESTED SPECIFICATION
Glass-lined storage tank(s) shall be A. O. SMITH glass-lined storage tank(s) or equal. Tank(s) shall be _” x _” and have a nominal capacity
of _ gallons. Tank(s) shall have threaded openings as shown on drawings. Exterior of tank(s) shall be thoroughly cleaned and painted.
Interior of tank(s) shall be glass-lined with an alkaline borosili-cate composition which has been fused to the steel base by firing at a
temperature of 1600°F. All internal surfaces exposed to water are glass-lined per ASME HLW code procedures using an NSF- approved
glass-lining compound. Cathodic protection shall be provided. The Storage Tank(s) shall have a working pressure of __psi. The Storage
Tank shall have a five-year limited warranty as outlined in the written warranty.
For Technical Information and Automated Fax Service, call 800-527-1953. A.O. Smith Corporation reserves the right to make product changes or improvements without prior notice.
Page 4 of 4
AOSTT35300
|