AMX Switch HD RD User Manual

Designer-Style Maestro® Remotes  
HD-RD, -RS  
120/127 V ~, 50/60 Hz  
Installation Instructions  
Please Read Before Installing  
Overview  
The HD-RD Remote Dimmer and the HD-RS Remote  
Switch are for use with HomeWorks Maestro Dimmers and  
Switches.  
Up to nine HD-RD Remote Dimmers may be used with a  
HomeWorks Wired or RF Maestro Dimmer, and up to nine  
HD-RS Remote Switches may be used with a HomeWorks  
Wired or RF Maestro Switch.  
Important Notes  
HD-RS  
HD-RD  
Codes: Install in accordance with all local and national elec-  
trical codes.  
Danger: These controls must not be used to con-  
trol equipment which is not visible from every con-  
trol location. They must also not be used to con-  
trol equipment which could create hazardous situ-  
ations such as entrapment if operated accidentally.  
Examples of such equipment which must not be operated  
by these controls include (but are not limited to) motorized  
gates, garage doors, industrial doors, microwave ovens,  
heating pads, etc. It is the installer’s responsibility to ensure  
that the equipment being controlled is visible from every  
control location and that only suitable equipment is connect-  
ed to these controls.  
Overheat Damage: To reduce the risk of overheating and  
possibly damaging other equipment, do not install  
to control receptacles or motor-operated appliances.  
Environment: Ambient operating temperature:  
0-40°C, 32-104°F, 0-90% humidity, non-condensing. Indoor  
use only.  
Spacing: If mounting one control above another, leave at  
least 4 1/2" (114mm) vertical space between them.  
Wallplates: Lutron Claro® and Satin ColorsTM wallplates are  
recommended for best color match and aesthetic appear-  
ance. Do not paint controls or wallplates.  
Cleaning: To clean, wipe with a clean damp cloth. DO NOT  
use any chemical cleaning solutions.  
Wallboxes: Lutron recommends using 3-1/2" (89mm) deep  
wallboxes for easier installation. Several controls may be  
installed in one multigang wallbox - see Multigang  
Installations (page 2).  
Remotes: Use only Lutron® HomeWorks Maestro Remote  
Dimmers (HD-RD) with HRD/HWD-6D, -6ND, -10D, -10ND,  
and -5NE controls. Use only Lutron HomeWorks Maestro  
Remote Switches (HD-RS) with HRD/HWD-8ANS controls.  
Up to 9 HD-RD or HD-RS controls may be used with a  
HomeWorks Maestro Dimmer or Switch. Mechanical 3- or 4-  
way switches will not work.  
1
 
Wiring Diagram 1  
Multi-Location Installation1  
-6D, -10D with HD-RD  
Remote Dimmer  
Black Red  
Dimmer  
Remote Dimmer  
Hot  
Black  
Red  
Black  
Red  
Lighting  
Load  
120/127VAC  
50/60Hz  
Green  
Blue  
Green  
Blue  
Green  
Blue  
Neutral  
Wiring Diagram 2  
Multi-Location Installation with Neutral1, 2  
-6ND, -10ND, -5NE with HD-RD, -8ANS with HD-RS  
Dimmer/  
Switch  
Remote  
Dimmer/Switch  
Remote  
Dimmer/Switch  
Hot  
Black  
Red  
Black  
Red  
Black  
Red  
Lighting  
Load  
120/127VAC  
50/60Hz  
Green  
Blue  
Green  
Blue  
Green  
Blue  
White  
Neutral  
1
2
Up to 9 HomeWorks® Maestro® Remote Dimmers/Switches may be connected to the HomeWorks Maestro Dimmer/Switch. Total Blue  
wire length may be up to 250' (76m).  
Remote Dimmers/Switches must be connected on the Line side of a multi-location installation when used with Neutral wire Dimmers or  
Switches.  
3
 
Wiring Diagram 3  
Installation with Power  
Booster or ELV Interface1, 2  
-6ND, -10ND with HD-RD  
NGRX-PB  
or  
ELVI-1000  
Remote  
Dimmer  
Dimmer  
Red  
Black  
Red  
Lighting  
Load  
Hot/Live  
Black  
120/127VAC  
50/60 Hz  
Green  
Blue  
Green  
Blue  
White  
Neutral  
Wiring Diagram 4  
Installation with Fluorescent  
Dimming Ballast Interface1, 2  
-6ND, -10ND with HD-RD  
Remote  
Dimmer  
Dimmer  
FDBI-16A-120  
Lutron® Hi-lume® Fluorescent  
Dimming Ballast(s)  
Red  
Black  
Red  
Hot/Live  
Black  
Orange  
Green  
Blue  
Green  
Blue  
120/127VAC  
50/60 Hz  
Black  
White  
White  
Neutral  
Wiring Diagram 5  
Installation with Neutral and  
Hi-Power Module1, 2  
-6ND, -10ND with HD-RD  
-8ANS with HD-RS  
HP 2•4•6TM  
Hi-Power Module  
N3 H3 DH3 SH3  
N2 H2 DH2 SH2  
N1 H1 DH1 SH1  
N
N
H
H
DH  
1
2
3
Lighting  
Load  
Remote  
Dimmer/Switch  
Control  
Dimmer/Switch  
Load  
Terminals  
Terminals  
Black  
Red Black  
N1 H1 DH1 SH1  
N
N
H
H
DH  
1
2
3
Red  
Green  
Green  
Blue  
White  
Blue  
Control Circuit  
Load Circuit  
1
Up to 9 HomeWorks® Maestro® Remote Dimmers/Switches may be connected to the HomeWorks Maestro Dimmer/Switch. Total blue  
wire length may be up to 250 ft. (76m).  
2
Remote Dimmers/Switches must be connected on the Line side of a multi-location installation when used with Neutral wire Dimmers or  
Switches.  
4
 
Local Operation  
Lamp Replacement  
Pressing the Tapswitch on any Dimmer, Switch, or  
Remote will alternately turn the lights ON and OFF. For  
HD-RD, the ON level will be the level previously set  
using the Dimming Rocker. Press and hold the top or  
bottom of the Dimming Rocker to raise or lower the light  
level.  
For routine lamp replacement, remove power from the  
fixture(s) by sliding the Front-Accessible Service Switch  
(FASS) to the OFF position (left). After replacing lamps,  
slide the FASS back to the ON position (right) to restore  
power.  
Danger - For any procedure other than routine  
lamp replacement, power must be disconnected  
at the main electrical panel.  
Double-tapping the Tapswitch on the HD-RD will turn the  
lights ON to full. Pressing and holding the Tapswitch for  
1/2 second (while ON) activates a 10-second long fade-  
to-off.  
Remote Dimmer Operation  
Tapswitch  
Tap on/off  
Dimming Rocker  
Press to Brighten  
Press to Dim  
FASSTM  
Front  
OFF  
ON  
Accessible  
Service  
Switch  
Remote Switch Operation  
Tapswitch  
Tap on/off  
FASS  
Front  
OFF  
ON  
Accessible  
Service  
Switch  
5
 
Troubleshooting Guide  
Symptom  
Cause and Action  
No lights at all  
Power not present  
• Circuit breaker OFF or tripped. Perform Short Circuit Check (see page 2).  
FASSTM in the OFF position. Move FASS to the ON position by sliding it to the right. Check both the  
dimmer/switch and all of the remote dimmers/switches.  
Wiring  
• Wires shorted. Make sure the blue wires are not grounded or shorted to any other wires.  
• Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.  
Lamps burned out  
• Replace lamps.  
Dioded lamps  
• If dioded lamps are being used, replace with non-dioded lamps.  
Wiring  
Lights turn ON when tap-  
switch is pressed, then turn  
OFF  
• Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.  
Tapswitch stuck  
• Tapswitch stuck at another location. Check to see that tapswitches are not sticking for all control loca-  
tions in the circuit.  
Light turns ON and OFF con-  
tinuously  
Load is less than minimum load requirement  
• Make sure the load connected to the dimmer or switch meets the appropriate minimum load require-  
ment for that control. See Load Specifications in the Installation Instructions for the dimmer or switch.  
Lights don’t switch when tap-  
switch is pressed  
Wiring  
• Wires shorted. Make sure the blue wires are not grounded or shorted to any other wires.  
• Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.  
Lights don’t switch ON/OFF  
when HD-RD or HD-RS tap-  
switch is pressed  
Wiring  
• Wires shorted. Make sure the blue wires are not grounded or shorted to any other wires.  
• Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.  
Lights don’t switch ON/OFF  
from Keypad  
Improper programming  
• Check programming in HomeWorks® Utility.  
Wiring  
• Wires shorted. Make sure the blue wires are not grounded or shorted to any other wires.  
• Wiring error. Check wiring to be sure it agrees with installation instructions and wiring diagrams.  
6
 
Notes:  
7
 
LIMITED WARRANTY  
Lutron will, at its option, repair or replace any unit that is defective in materials or manufac-  
ture within two years after purchase. For warranty service, return unit to place of purchase or  
mail to Lutron at 7200 Suter Rd., Coopersburg, PA 18036-1299, postage pre-paid. Telephone  
the Lutron Technical Support Center toll free at 800-523-9466. After the two year period, a  
pro-rated warranty applies to this product until eight years after the purchase. For more infor-  
mation regarding this warranty contact your Lutron representative.  
THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES, AND THE  
IMPLIED WARRANTY OF MERCHANTABILITY IS LIMITED TO TWO YEARS FROM PUR-  
CHASE. THIS WARRANTY DOES NOT COVER THE COST OF INSTALLATION,  
REMOVAL OR REINSTALLATION, OR DAMAGE RESULTING FROM MISUSE, ABUSE,  
OR IMPROPER OR INCORRECT REPAIR, OR DAMAGE FROM IMPROPER WIRING OR  
INSTALLATION. THIS WARRANTY DOES NOT COVER INCIDENTAL OR CONSEQUEN-  
TIAL DAMAGES. LUTRON’S LIABILITY ON ANY CLAIM FOR DAMAGES ARISING OUT  
OF OR IN CONNECTION WITH THE MANUFACTURE, SALE, INSTALLATION, DELIVERY,  
OR USE OF THE UNIT SHALL NEVER EXCEED THE PURCHASE PRICE OF THE UNIT.  
This warranty gives you specific legal rights, and you may also have other rights which vary  
from state to state. Some states do not allow limitations on how long an implied warranty lasts,  
so the above limitation may not apply to you. Some states do not allow the exclusion or limi-  
tation of incidental or consequential damages, so the above limitation or exclusion may not  
apply to you.  
Technical and Sales Assistance  
If you need assistance, call the toll-free Lutron  
Technical Support Center. Please provide exact  
model number when calling.  
(800) 523-9466 (U.S.A., Canada and the Caribbean)  
Other countries call:  
Tel: (610) 282-3800  
This product may be covered by one or more of the following U.S. patents: 5,248,919;  
5,399,940; 5,637,930; D353,798 and corresponding foreign patents. U.S. and foreign patents  
pending. Lutron, Claro, Maestro, Hi-lume and HomeWorks are registered trademarks and  
Satin Colors, HP 2•4•6, FASS and the HomeWorks Logo are trademarks of Lutron Electronics  
Co., Inc.  
Fax: (610) 282-3090  
© 2003 Lutron Electronics Co., Inc.  
Lutron Electronics Co., Inc.  
7200 Suter Road  
Coopersburg, PA 18036-1299  
Made and printed in the U.S.A. 02/03 P/N 043-134 Rev. A 93-2605-02  
 

ABC Office Paper Shredder FD 572 User Manual
Actron Automobile Parts CP7676 User Manual
Agilent Technologies Network Router Z5623A User Manual
AKG Acoustics Microphone C 535 EB User Manual
Alcatel Lucent Network Router 5750 SSC User Manual
AllerAir Air Cleaner 700 1000 User Manual
Allied Telesis Power Supply AT PWR14 User Manual
Altinex Switch MX2406RM User Manual
Audiovox Automobile Electronics 128 8602 User Manual
Barco Projector PGWU 62L K User Manual